IN THE BOX
Solar Panel *1
Universal Joint *1
Base *1
Screws *3
Wall Anchors *3
INSTALLATION
Position the Solar Panel in an area with consistent sunlight throughout the year. It only requires a few hours of direct sunlight each day to keep yourcamera powered.
The solar panel’s energy output is affected by weather conditions, seasonachanges, geographic location, etc.
Attach the base to your mounting location using the included screws. If the installation surface is soft or unstable, first use a 6.0 drill bit to drill a hole in the wall, then insert the anchor nail into the hole, and secure the base with screws.
Screw the universal joint into the back of the solar panel. Tighten it firmly with the attached nut.
Screw the locking screw cap into the base. Ensure that the universal joint is angled upward.
To adjust the solar panel’s position left or right, loosen the universal joint, and tighten the universal joint when the panel is in the desired position.
The solar panel’s angle can be adjusted up and down up to 90°.
Tip: After completing the installation, please check that all locking mechanisms are securely fastened.
HOW TO POSITION YOUR SOLAR PANEL
1.Find an area that receives the most direct sunlight throughout the day.
2.Angle the solar panel upward 30°
3.Point it south if in the northern hemisphere and north if in the southernhemisphere.
IMPORTANT
Regularly wipe the face of the solar panel with a soft, damp cloth to clearany dust or debris.
Ensure you update the camera’s firmware to the latest version.
BASIC PARAMETERS
Cable length: 3m
Operating voltage: 5V DC
Operating temperature: -20.5C to 48.5C (-5F to 120F)
FCC WARNING
Any changes or modifications not expressly approved by the responsibleparty for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC RulesOperation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, includinginterference that may cause undesired operation.
ISEDC RSS WARNING
This device complies with ISEDC license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.